TagLine Here

eb301 Buetooth


The eb301 is a carrier board that has an eb100 Bluetooth module attached and contains buffers and a voltage regulator. There is a U.FL antenna connector for antenna output. The board runs on 5V and supports 5V TTL Signals. For minimal operation only 5 pins are used, RX,TX, 5V, GND and Antenna.

The Bluetooth module uses a simple command set to configure and connect to another device. The data transfer rate of up to 250kbps of continuous data throughput is supported. The module requires 3.3V at 125uA standby and up to 60 mA in pairing mode.

The module is based on the CSR BlueCore™ Bluetooth Chip. This Chip supports both TTL Serial and USB with very few external components.

These are great for Arduino to allow wirelessly communication to a PC or Smart Phone. These modules can be either Master or Slave so two modules can talk to each other and either can start the conversation.

These modules are New Surplus. They have no box or manual. Specification and pinout will be provided.

Information at my website.

CSR is a chip manufacture and all Copyrights and Trademarks apply.
BlueCore™ is Trademarked by CSR.

Add to Cart:

  • Model: eb301
  • Shipping Weight: 0.2lbs
  • 7 Units in Stock

This product was added to our catalog on Tuesday 24 July, 2012.

Your IP Address is:
Copyright © 2019 Hackers' Warehouse. Powered by Zen Cart