Arduino IDE problems....

[jackneeson]

Hello,

I recently purchased an Arduino Nano to use with my Raspberry Pi... I installed the official Arduino IDE with the command: 'sudo apt-get install arduino'. And all appears to be fine until you run it! You get the classic Arduino interface BUT WITH NOTHING ELSE.... It has no options to compile or to Debug or even to change the board that you are using! It is simply nothing more than a text editor! I though that the Raspberry Pi could be a fully established Arduino host PC... Was I wrong???

Please help

I didn't find the right solution from the internet.

References:
https://www.raspberrypi.org/forums/view ... hp?t=17472

Thank you